Reference [Mixer]
ZOOM MRS-1608
83
While the SUB-OUT SEND ON/OFF parameter of the
master track is ON, the indication “xxx SUB SEND
MASTER” (where xxx is the track/input name) will be
shown when another track or input is called up. For this
track/input, the SUB-OUT SEND parameter cannot be
modified.
3.
Turn the dial to set the parameter to OFF.
In this condition, the signal level to be sent from each
track/input to the STEREO SUB-OUT jack can be
adjusted individually.
HINT
•You can also switch between ON and OFF by pressing the
[SUB-OUT SEND] key.
• By selecting ON, you can return to the original condition at
any time.
4.
Use the cursor left/right keys and status
keys to select the track/input, and turn the
dial to adjust the level of the signal sent to
the STEREO SUB-OUT jack.
When the project is in the default condition, the SUB-
OUT SEND LVL parameter is set to zero for all tracks/
inputs. A setting of 100 will result in a unity gain (0 dB)
signal being sent to the STEREO SUB-OUT jack.
5.
Press the cursor down key until the
following indication appears. Then turn the
dial to set the panning value of the signal
sent to the STEREO SUB-OUT jack.
The panning value setting range is L100 (fully left) – 0
(center) – R100 (fully right). By pressing the cursor up
key, you can return to the condition of step 4.
6.
Repeat steps 4 – 5 to adjust the output level
for all track/input signals sent to the
STEREO SUB-OUT jack.
You can set the SUB-OUT SEND parameter for a track/
input to OFF by pressing the [SUB-OUT SEND] key
repeatedly so that the key goes out. This is useful to
temporarily take that track/input out of the mix. Pressing
the key again turns it ON and restores the original
condition.
7.
To return to the main screen, press the
[EXIT] key.
MASTER
SUB SEND
ON
TR1
SUB SEND
LVL 100
TR2
SUB SEND
Pan R32
1608E.book 83 ページ 2004年4月19日 月曜日 午前10時44分
Comments to this Manuals