Reference [Other Functions]
ZOOM MRS-1608
183
3.
Use the cursor left/right keys to bring up
the indication “UTILITY LVL MET” on the
display, and press the [ENTER] key.
The current level meter setting will be displayed.
The settings have the following meaning.
●
POST (default setting)
The meter shows the level of the signal after passing
through the faders and [REC LEVEL] control.
●
PRE
The meter shows the level of the signal before passing
through the faders and [REC LEVEL] control.
4.
Turn the dial to change the setting.
5.
To return to the main screen, press the
[EXIT] key several times.
If the optional USB board UIB-02 is installed in the
MRS-1608, the internal hard disk of the MRS-1608 can
be recognized by a computer (Windows/Macintosh) as an
external hard disk. This allows audio data transferring,
project backup etc. To make this possible, connect the
computer and MRS-1608 with a USB cable and switch
the MRS-1608 to USB mode, as described below.
HINT
The UIB-02 supports Windows (98/98SE/Me/2000/XP) and
MacOS (9.1/9.2/MacOS X). Depending on the computer and
the operating system, driver installation may be required. For
details, see the on-line manual supplied with the UIB-02.
1.
Verify that the recorder is stopped. Then
connect the option board to a USB port on
the computer, using a USB cable.
2.
From the main screen, press the [USB] key
in the control section.
The display changes as follows.
3.
Press the [ENTER] key.
The indication “UIB WORKING” appears on the display,
and the MRS-1608 switches to UIB mode.
When UIB mode is activated, the computer automatically
recognizes the internal hard disk of the MRS-1608 and
goes into the on-line state.
For details on operation, see the on-line manual supplied
with the UIB-02.
4.
To terminate the connection, cancel the on-
line state at the computer.
SYSTEM
FOOT SW
LVL MET
POST
Using an option card to
connect to a computer
UIB MODE
SURE?
UIB
WORKING
1608E.book 183 ページ 2004年4月19日 月曜日 午前10時44分
Comments to this Manuals