Zoom 2100 Instruction Manual Page 70

  • Download
  • Add to my manuals
  • Print
  • Page
    / 212
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 69
1
Set the mode dial to .
2
Compose the picture by turning
the camera towards the subject.
3
Press the shutter button halfway
to lock the focus and exposure.
Use the focus lock if the camera
itself cannot focus the subject
(P.93).
The AF confirmation mark will light
up and the camera will beep.
The AF confirmation mark will blink
if the focus and exposure are not
locked. Please refer to SUBJECTS
THAT ARE HARD TO FOCUS,
P.92.
4
Press the shutter button fully.
Recording will start. To stop
recording, press the shutter
button fully again.
The mark will light up in red
while shooting movies.
You cannot take movies if the entire
image memory gauge is lit up.
The seconds of recording time
remaining in the memory will
appear on the monitor.
When recording starts, correct
focusing and exposure is
maintained continuously.
5
The card access lamp will blink
and the camera will begin storing
images onto the card.
You cannot take the next movie
until the camera is finished storing
the current one, even if the
memory indicates that there is
sufficient memory.
70
TAKING PICTURES (Cont.)
Recording movies
1 3, 4
3 4
F2.8 1/30 0.0
Seconds remaining
Memory gauge
..
To record the next movie
picture
Wait until the card access lamp
goes off and writing of movie
pictures into the card is finished.
Page view 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 211 212

Comments to this Manuals

No comments