Zoom MRS-1044 Installation Manual download pdf (Page 11)

ZOOM UIB-01

UIB-01 Applications

This section describes the various uses of the UIB-01.

Project backup/restore

You can copy a project from the MRS-1044 recognized as a local disk to

the hard disk of the computer, for creating a backup. A backed-up project

can be restored to the MRS-1044 at any time.

Backing up a project

Start up the MRS-1044 in USB mode and connect it to the

computer with a USB cable.

Verify that the online state is established.

Open "My Computer" and double-click on the local disk

representing the MRS-1044.

The contents of the MRS-1044 hard disk are shown. Project data are

stored separately in folders named "PROJxxx" (where "xxx" is the

project number from 000 - 999).

Other folders and files are used by the system of the MRS-1044.

Take care not to accidentally delete these. For information on the

contents of the MRS-1044 hard disk, see p. 28.

ZOOM UIB-01

UIB-01 Applications

Preparations

The computer and MRS-1044 are now in the offline state, and you

can terminate the USB connection.

In the offline state, the "USB Storage Unplug" icon should

disappear from the task tray. If not, right-click on the icon and

select [End of USB Storage Unplug].

Push the [POWER] switch of the MRS-1044.

The indication "PowrOFF ENT/EXIT" appears on the display of the

MRS-1044.

Press the [ENTER] key of the MRS-1044.

Power to the MRS-1044 is turned off. When you turn the power on

again in this state, the unit starts up normally.

If necessary, disconnect the USB cable.

This procedure must be followed every time you wish to terminate

the USB connection between the computer and the MRS-1044 to

turn the MRS-1044 off.

NOTE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Zoom MRS-1044 Installation Manual Page 11