Zoom X5V User Manual download pdf (Page 41)

Chapter 3: Advanced Setup Options 41

3.2 How To Set Up Your X5v To

Use a Static IP Address

Most DSL service providers use DHCP, also known as dynamic IP

addressing, rather than static IP addresses. If your provider is using

1483 Bridged or Routed IP encapsulation, however, you have the

option of using a static IP address. Typically, you must request (and

pay extra) for a static IP address. To set up your X5v to use a static

IP address, go to the WAN Settings page, and fill out these fields.

Encapsulation

Enter the encapsulation mode supplied by your

provider. Remember, it must begin with either

1483 Bridged

1483 Routed IP

; otherwise,

you cannot use a static IP address.

VPI

Supplied by your service provider. You can refer

to the tables beginning on page 65 if you have

misplaced or forgotten your VPI setting.

VCI

Supplied by your service provider. You can refer

to the tables beginning on page 65 if you have

misplaced or forgotten your VCI setting.

DHCP client enable

You must uncheck this box. It

must

be disabled.

Static IP Address

Enter the static IP address supplied by your

service provider.

Subnet Mask

Enter the subnet mask of the static IP address

given to you by your service provider.

Default Gateway

Enter the default gateway IP address given to

you by your service provider.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 79 80

No comments

Zoom X5V User Manual Page 41