Zoom ST-224 User Manual download pdf (Page 52)

The [SONG FUNCTION] LED flashes.

When the [SONG FUNCTION] key is pressed, the pads serve to

select the parameters printed at the bottom right. When a pad is

pressed, the [SONG FUNCTION] LED and the LED of the pad are

constantly lit, and the setting of the respective parameter appears on

the display. (For details on the song function parameters, see page

53.)

The [SONG FUNCTION] LED goes out and the changed parameter is

accepted. To cancel the parameter change, press the [EXIT] key

instead of the [SONG FUNCTION] key.

Creating Songs

The length of a song or the number of beats, the metronome sound volume, pre-count setting and other

song settings (song function parameters) can be changed, as follows.

BANK

SONG

PAD

FUNCTION

PAD ASSIGN

CAPACITY

ERASE OPTIMIZE

PLAY/STOP

RECORD

EDIT 2

EXTREME EQ

RESONANCE

HIGH-PASS

LOW- PASS

DISTORTION

RING MODULATOR

PITCH SHIFTER

DIMENSION

CHORUS

PHASER

EFFECT

ON/OFF

PAD ENABLE

EFFECT SYNC

EDIT 1

LOOP/MARK

SHIFT

OFFSET

SWING

PANNING

MIDI

TRIGGER/GATE

QUANTIZE

TUNING

SOURCE

SOURCE MIX

PRE COUNT

END POINT

TIME SIG

START POINT

BAR LENGTH

LEVEL

CLICK VOLUME

REVERSE

COPY DELETE

BACKUP

EXIT

SPECIAL

LOAD SAVE

INTERNAL/DATA CARD

–

AUTO SYNC

PLAYLIST

TAP

BPM

MEASURE

SAMPLE/SONGBEAT

SONG

PAD

FUNCTION

SONG

PAD

FUNCTION

Pads 1 – 8

+–

[–] [+] keys

+–

EDIT 1

[EDIT 1]

wheel

[–] [+] keys

Press the [SONG FUNCTION] key.

STEP

In play mode, use the [-] [+] keys to select the song number (1 - 8).

STEP

Select the item to be set, using pads 1 - 8.

STEP

Use the [-] [+] keys or the [EDIT 1] wheel to change the setting.

STEP

Press the [SONG FUNCTION] key again.

STEP

Changing Song Settings

Parameter setting values

BPM/

VALUE

MEASURE

SAMPLE/SONGBEAT

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 75 76

Comments to this Manuals

No comments

Zoom ST-224 User Manual Page 52

Comments to this Manuals

Related products and manuals for Musical Instruments Zoom ST-224