Zoom BFX-708 Specifications download pdf (Page 22)

ZOOM BFX-708

In play mode, when a patch where JAM Play

can be used is selected, the REV and PEDAL

module LEDs are flashing.

7 Push down the expression pedal fully.

The BFX-708 enters the Jam Play mode and

goes into the recording standby condition. The

indication "JP" is shown on the BANK/PATCH

indicator.

8 While playing your instrument, press the ▲

foot switch when you want to start

recording.

As opposed to the regular sampler function, the

signal recorded for Jam Play always is

processed by the currently selected effects.

9 To stop recording midway, press the ▼

foot switch. Alternatively, after 2 seconds,

recording stops automatically.

10

Use the ▼ foot switch or the expression

pedal to control play/stop of the recorded

phrase.

The function of the ▼ foot switch and expression

pedal depends on the STYLE parameter and

TRG/GT parameter setting.

When "nM" or "rS" is selected as STYLE

parameter, the expression pedal can be used to

adjust the level of the playback signal.

To record and play a new phrase, repeat steps

8 - 10.

11

To terminate the Jam Play mode, push the

expression pedal once more fully down or

press the EDIT (CANCEL) key.

Also after terminating the Jam Play mode, the

most recent recorded phrase is temporarily

retained by the unit and can be used again

when a patch is selected for which Jam Play is

enabled. If Jam Play is enabled for both

patches, it is also possible to switch between

patches while playing the recorded phrase.

When the regular sampler is used or when the

unit is turned off, the phrase is cleared.

The expression pedal of the BFX-708 can be used to control the volume or parameters of the COMP•DIST, MOD,

and REV modules in real time.

1 In edit mode, use the MODULE / keys

to cause the PEDAL module LED to flash.

When wishing to control a parameter with the

expression pedal, the parameter must first be

assigned to the pedal in edit mode.

2 Use the parameter knob 1 to select the

assign target for the expression pedal.

Parameter 1 of the PEDAL module is the

ASSIGN parameter.

The following targets can be selected: "VL"

(Volume), "dS" (COMP•DIST module), "Md"

(MOD module), "rv" (REV module). When a

module to which the pedal is assigned is called

up, the indication "Pd" appears on the

BANK/PATCH indicator.

The parameter that is actually controlled is

predetermined for every effect type in the

module. This parameter is indicated by a pedal

mark in the description on pages 17 through 20.

3 Use parameter knob 2 to select the way

the parameter changes when the pedal is

moved.

Parameter 2 is the MODE parameter that

determines the range and direction of the

change caused by the expression pedal.

Available settings are "UP", "dn" (Down), Hi

(High), Lo (Low).

4 Store the patch and return to the play

mode.

Verify that the module to which the pedal was

assigned is ON.

22

Controlling an Effect With the Pedal

dn

UP

Parameter value

Lo

Hi

Value

programmed

in patch

Maximum value

Minimum value

Controlling an Effect With the Pedal

1 2 ... 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments