The RhythmTrak •••234 switches to pattern mode and the number
of the currently selected pattern is shown on the [SONG/PATTERN]
display. 01 - 99 indicates a user pattern, and P01 - P99 a preset
pattern. The [VALUE] display shows the current position in the
pattern (measure/beat). If an empty user pattern was selected, the
[VALUE] display shows "----".
In pattern mode, the [UP/DOWN] keys serve to switch the pattern.
You can also hold the [PATTERN] key down and use the [SOUND
JAMMER] slider to select a pattern.
The [START] key LED lights up, and the pattern is played
repeatedly. The [TEMPO] key LED flashes according to the tempo
of the pattern. The [VALUE] display shows the current position in
the pattern (measure/beat).
Pressing the [VALUE UP] key during pattern playback turns off the
sound of tracks other than the currently selected track (whose
[KIT/TRACK SELECT] LED is lit). Pressing the [VALUE DOWN] key
turns off the sound of the currently selected track.
Pressing the [START] key instead of the [STOP] key sets the unit to
pause mode. The [START] key LED flashes. Pressing the [START]
key again in this condition resumes playback.
15
Playing the Patterns (Pattern Mode)
Pattern play
Playing the Patterns (Pattern Mode)
This section describes how to play patterns that are built into the RhythmTrak •••234 or that have been
recorded by the user.
The RhythmTrak
•••234 incorporates 99 preset patterns (P01 - P99) which cannot be changed by the user,
as well as 99 user-definable patterns (01 - 99). The unit is shipped with the user patterns programmed
with the same contents as the preset patterns, but these contents can be changed freely. The section below
describes how to play back a pattern.
Also while playing a pattern, you can use the pads for manual
play. However, the [SOUND JAMMER] slider has no modifying
effect on the playback sound of the pattern.
Comments to this Manuals