Zoom R24 Installation Guide download pdf (Page 28)

Audio interface manual

Effects in audio interface mode

The R24’s insert and send-return effects can both be used when the sampling

frequency is set to 44.1 kHz. Basic operation is the same but there are a few

differences in the menus.

NOTE

• Effects can only be used when the sampling rate

is 44.1 kHz. At all other times it is turned OFF.

• Insert and send return effect settings are saved

when you terminate (EXIT) audio interface mode

and can be used again the next time.

Insert effect Send return effect

As in recording mode, you can select the insert

location and the insert effect algorithm, as well

as the effect patches to be applied to the sig-

nal being recorded.

INSERT EFFECT menu

Select the insert location

Insert on any

INPUT 1~8

(Reference: Operation Manual )

Apply the effect only to monitoring

The effect can be set to only be applied to the monitoring

signal and to not affect signals recorded in DAW software.

(Reference: Operation Manual )

As in recorder mode, use the

SEND REVERB

menu to change the patch and use the

PAN/EQ

menu to set the

REV SEND

level that adjusts the

reverb depth.

Setting the reverb send level

REVERB SEND

Adjust the amount of reverb using the

REV

SEND

level of the

PAN/EQ

menu.

(Reference: Operation Manual )

(Reference:

Audio interface manual – Mixer

)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Zoom R24 Installation Guide Page 28

Comments to this Manuals

Related products and manuals for Audio equalizers Zoom R24